PUTSCH® Belt Type Rock Catchers
The PUTSCH® Belt Type Rock Catcher consists of a flume water channel piece with a basin collecting device for the rocks and a connecting elevator for the removal of the separated rocks. It works continuously. To avoid beets falling through the rock discharge opening, buoyancy water runs through the rock discharge opening to the flume stream. The emergency locking device consists of a double hatch with a shaft arrangement diagonal to the flume stream. The pump performance for the buoyancy water has to be adjusted to each condition. The speed of this water determines the separation degree. The rock elevator is a continuous bucket device. The buckets are bolted close to each other to steel reinforced rubber belts. In the upper part of the rock catcher the belts run over bearing equipped beelt wheels. The belt tension takes place in the lower part with looselyplaced profile rings.Maintenance on the steel reinforced rubber belts is much less than on chain bucket belts and is therefore very advantageous to the customer.
|
|
GSA 1
|
GSA 2
|
GSA 3
|
|
Measurements:
Length: Width: Height: |
9 ft (2780 mm) 6.5 ft (2000 mm) 5.9 ft (1820 mm) |
11 ft (3380 mm) 8.3 ft (2540 mm) 11 ft (3372 mm) |
13 ft (4080 mm) 9.4 ft (2870 mm) 14 ft (4270 mm) |
|
Distance between buckets:
|
4" (100 mm)
|
8" (200 mm)
|
10" (250 mm)
|
|
Inlet height:
|
3.6 ft (1125 mm)
|
9.7 ft (1400 mm)
|
6.5 ft (2010 mm)
|
|
Rock discharge opening:
|
8" x 8"
(200 x 200 mm) |
12.9" x 16"
(330 x 400 mm) |
16" x 16"
(400 x 400 mm) |
|
Bucket size:
|
7" x 8.5"
(180 x 310 mm) |
14.7" x 26.7"
(375 x 680 mm) |
17" x 32"
(435 x 820 mm) |
* Subject to change.
Site map |